Description

FT-MTRA-3E30Ais a high performance, cost effective modules, which is supporting Multi Rate 9.953-25.78Gbps, and transmission distance up to 10km on SM fiber. The transceiver consists of two sections: The transmitter section incorporates a 1310nm DFB Laser, a driver and a CDR. The receiver section consists of a PIN photodiode integrated with a transimpedance preamplifier (TIA), a Limitting Amplifier and CDR. The module is hot pluggable into the 20-pin connector. The high-speed electrical interface is base on low voltage logic, with nominal 100 Ohms differential impedance and AC coupled in the module.

The optical output can be disabled by LVTTL logic high-level input of TX_DIS. Transmit Fault (Tx_Fault) is provided to indicate that the module transmitter has detected a fault condition related to laser operation or safety. Loss of signal (RX_LOS) output is provided to indicate the loss of an input optical signal of receiver.  

A serial EEPROM in the transceiver allows the user to access transceiver monitoring and configuration data via the 2-wire SFP

Management Interface. Digital diagnostics function are available via a 2-wire serial interface, as specified in SFF-8472.

Features

●  Up to 10KM transmission distance

●  Support Multi Rate 9.953-25.78Gbps

●  1310nm DFB and PIN receiver

●  SFI electrical interface

●  2-wire interface for integrated Digital Diagnostic monitoring

●  SFP+ MSA package with duplex LC connector

●  H ot pluggable

●  Very low EMI and excellent ESD protection

●  +3.3V power supply

●  Power consumption less than 1.5W

●  Operating case temperature: 0~70°C

Applications  

●  25Gbps Ethernet

Compliance  

●  Compliant with IEEE 802.3-2012

●  Compliant with FCC 47 CFR Part 15, Class B

●  Compliant with MSA SFF-8472

●  Compliant with MSA SFF-8431

Specification

Notes:

[1]Under CDR bypass mode, CPRI option 7 compatibility

[2] 1000 consecutive snapshots at typical rate and room temperature

[3] Measured with a 4.7k Ohm load pulled up to Vcc

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.